Other » 2D drawings.

Hello,

First time using the 2D Drawing section. I'm having problems trying to find out how to show dashed lines for hidden edges.

Example - take a counterbored hole. Looking at the counterbored side, you see two concentric circles (solid lines), one for the hole and the 2nd for the counterbore.

Flip the part 180 degrees and I was expecting to see a solid inner circle and a dashed outer circle for the counterbore, but nothing is there.

Likewise, how could I enable dashed lines to show the counterbored hole "sideways" (i.e. not looking end-on at either end of the counterbored hole).

I've recently started a job in an engineering job shop and the first drawing I was shown was done this way.

please help

Thanks !

I didn't find the right solution from the internet.

References:
https://www.alibreforum.com/forum/index....drawings.19776/


Best Internet Marketing Examples